VLAN #. The source IP address will be the VLAN IP address selected. The ping will continue to follow the same routing as clients connected on the LAN of the WAN Appliance. For most people, MOS ratings of 4 or higher are considered good, while anything below 2.5 is considered unacceptable. The ping will continue to follow the same routing as clients connected on the LAN of the WAN Appliance. In the case of network testing tools like PingPlotter, MOS is approximated based on the latency, packet loss, and jitter of your current connection using a dedicated formula. Internet #. The source IP address will be the WAN IP address selected. Internet example: If you input a destination IP that resides on the WAN/internet, the WAN Appliance will source the ping from the configured WAN Appliance primary uplink (as configured on SD-WAN and traffic shaping).Ping rate of between 100 and 300 ms (0.1 and 0.3 seconds) Unplayable ping (Long delays are almost unavoidable) See also: What is a good ping download and upload speed. Ping rate of between 50 and 100 ms (0.05 and 0.1 seconds) Poor ping for online gaming, especially fast-paced online gaming. Site-to-site VPN example: If you input a destination IP that resides across a site-to-site VPN, the WAN Appliance will source the ping from the WAN Appliance VLAN interface IP of the highest VLAN ID that is participating in the VPN Average ping but still acceptable for online gaming.Because UDP scanning is generally slower and more difficult than TCP, some security auditors ignore these ports. DNS, SNMP, and DHCP (registered ports 53, 161/162, and 67/68) are three of the most common. LAN example: If you input a destination IP that is in VLAN A, the WAN Appliance will source the ping from its VLAN A interface IP iPerf3 is a tool for active measurements of the maximum achievable bandwidth on IP networks. ) While most popular services on the Internet run over the TCP protocol, UDP services are widely deployed.The ping tool now has a drop down to select the source IP address for pinging destinations from the WAN Appliance.ĭefault. The WAN Appliance uses the route table to dynamically choose the ping source IP address closest to the destination IP entered. For WAN Appliances running firmware MX 15.12+, additional ping options have been added to the live tool.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |